Prime Wood Preserver

Water based wood preservative (brown/green)
General Information
Prime Wood Preserver is a general-purpose water-based preserver for interior or exterior use. It gives deep penetrating protection for wood against decay, insects, and fungi. Prime Wood Preserver is available in 2 colors and can be applied by brush or dipping.
General Features
  • Clear
  • Odorless
  • Easy application (brush or dipping)
  • Prevents decay from fungi and insects
  • Complies with European Norms
  • Environmentally friendly
  • Ready to use
Where to Use
  • Exterior softwoods to be painted above ground level
Packaging
  • 5 L.
  • 20 L.
  • 200 L. (Upon request)
Color Chart

Brown

Green

Clear

Warning:

The above colors are applied on pine and are intended to approximate the final color. The color obtained will vary according to the type, texture and the absorbency of the wood. To see the final color, it is recommended to apply the coating on the wood to be actually used.

Surface Preparation
  • Wood should be completely clean and moisture below 20%
Application
  • The product is ready to use and does not require thinning.
    • Application by Brush:
      • Apply the product by brush until it gets completely wet.
      • Wait 24 hours for complete dry before coating.
    • Application by Dipping:
      • Dip the timber in a stainless steel, polyester or polypropylene tank containing Prime Wood Preserver.
      • The dipping time for softwoods is approximately 6 minutes.
      • Take out the treated timber over the tank and allow the preservative on the surface to drip for around 2-3 minutes.
      • Wait 24 hours for complete dry before coating.
Maintenance
  • Clean the wood surface completely from stain, dust and oil and perform a slight sanding.
  • Thoroughly clean the generated dust
  • Repeat same process as described in "application".
Information

The life of the wood increases with regular maintenance. Check your wood every year to maintain ideal protection and maintain as required.

General Instructions

For product application, health and safety information, read the product's Technical Data Sheet and Safety Data Sheet (SDS) from the documents section.

Documents
TDS

Technical Data Sheet

SDS

Safety Data Sheet

EN71-3

Toy Safety Certificate

Tips
  • Apply the product in the afternoon to minimize the waiting time between the stain application and Impregnation. Proceed stain application the next morning.
  • You can remove the worm sounds coming from your woods with a syringe by squeezing the product into the holes opened by the worms.
  • In order to accelerate the drying time after the impregnation process, ensure that each surface of the wood is thoroughly ventilated by stacking the grid.
  • In the case of unstructured large-scale projects, the impregnation process can be quickly completed with the dipping method.
  • Cover the impregnation tank after the impregnation process in order not to lose its effect for the next process.
TOP